11 Measures to Spray Paint Your Car Like the Professionals - Automobile Bodywork Paint Repair

You may be surprised to see only the best way to spray auto paint really can be easy. That does not mean that you go at it and can only grab a tin of paint. There are some fundamentals you need to understand. Both in application and the preparation.

Step A:

Prepare by assembling all of your items that you are going to need. Make certain your surrounding area is protected against any possible over aerosol. Any parts that do not need to be sprayed and that can be removed then do so. For other places cover nicely with paper and masking tape.

Measure B:

You may need to analyze the car carefully for any rough spots. These will need to be sanded with 300 grit sand paper. This will smooth out the rough spots. In addition, it allows the aerosol car paint to adhere better. Once you have finished sanding, make sure all the dust dirt and debris are removed from the vehicle. It is imperative that the car be absolutely clean.



Step C:

You will need to apply a primer. This will make sure you get an overall even layer of your colored paint plus helps the paint to adhere nicely. Be sure to apply light layers and allow for drying in between, when you spray the primer. How to spray auto paint takes a little getting used to.

Step D:

Now you might be well to the point where you're about ready to spray on the colour. Before you start with the auto in any case, make a couple of practice strokes on an object. Once you're ready, start the passes with the paint without hesitation. You may end up getting uneven coverage if you hold the spray can or gun in one area and possibly the paint will run. If it happens you've got a significant repair job on your had. You'll most likely have instructions regarding how you can spray auto paint using the spray or gear cans.

Step E:

Check with someone which is comfortable with the way to spray on car paint, or you may want to research this option on the internet

Step F:

You are down to the finishing touches once you're absolutely satisfied with the color. You may now want to apply several coatings that are clear. This will give the gloss and finished appearance to the auto in addition to protect Alloy Wheel Repair Essex the finish. Likely two layers will be sufficient but it's going to be up to you personally. Make absolutely sure it is dry in between coats.

Step G:

If you favor yet again, you've the choice of wet sanding. Again, I recommend you ask the advice of people which can be familiar with the way to spray paint a car. You need with these grits in this sequence if you decide to follow this measure then. Use 800, 1000, 1200, 1500 and the finally the 2000. This will remove spots that could not be overly light in the clear coating application.

Step H:

Step I:

You should now buff the surface. To do this simply use a moderate cut polish.

Step J:

As a final touch, you may want to apply a few layers of wax.